Accord EX Sedan V6-3.0L (2001)
9.
Insert the guide part of the drill bit into the EGR port. Make sure it is inserted fully. Then drill out the EGR port using steady pressure on the drill.
Make sure the port is drilled through completely.
10.
Clean up the aluminum chips from drilling, then remove the duct tape.
11.
Put the manifold in a parts washer (solvent or soap and water) and clean it thoroughly.
^
Flush out the EGR port for 20 seconds.
^
Flush out the manifold from the throttle body opening. Run cleaner down each side for 20 seconds.
^
Flush each intake runner for 10 seconds. Start at the throttle body end and work towards the back.
^
Turn the manifold so the throttle body opening is facing down. Flush each main runner for 20 seconds.
^
Dry the manifold with compressed air and clean shop towels.
