Accord LX Coupe L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-2445003.png)
14. Disconnect the dashboard wire harness 16P connector (A) from the gauge assembly.
Dashboard Wire Harness 16P Connector (Wire Side Of Female Terminals)
15. Check resistance between the No.9 terminal of the dashboard wire harness 16P connector and ground. There should be 1 M ohm or more.
Is the resistance as specified?
YES - Short to ground in the gauge assembly; replace the gauge assembly.
NO - Go to step 23.
16. Turn the ignition switch OFF.
17. Remove the gauge assembly. Do not disconnect the connector from the gauge assembly.
18. Turn the ignition switch ON (II).
19. Connect the No.9 terminal of the dashboard wire harness 16P connector and No.11 terminal of the dashboard wire harness 22P connector with a
jumper wire.
Does the SRS indicator light go off?
YES - Go to step 20.
NO - Faulty SRS indicator light circuit in the gauge assembly; replace the SRS printed circuit board in the gauge assembly.
20. Turn the ignition switch OFF.
