Accord LX Coupe L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
5. Install the new oil seal (A) in the clutch housing (B) with the special tools.
CARRIER BEARINGS PRELOAD ADJUSTMENT
Special Tools Required
-
Driver 07749-0010000
-
Attachment 52 x 55 mm 07746-0010400
-
Attachment 62 x 68 mm 07746-0010500
-
Attachment 72 x 75 mm 07746-0010600
If any of the items listed below were replaced, the carrier bearing preload must be adjusted.
-
Transmission housing
-
Clutch housing
-
Differential carrier
-
Carrier bearing and outer race
1. Remove the oil seals from the transmission housing and clutch housing.
Thrust Shim Replacement (Transmission Housing)
2. Drive the bearing outer race (A) and thrust shim (B) out of the transmission housing (C). Do not reuse the thrust shim. If you replaced the carrier
bearing on the transmission housing side of the carrier, discard the outer race.