Accord LX Coupe V6-3.0L (2001)
NOTE: Do not mix the mender and hardener in excess of 20g (0.7oz) at a time.
-2.Hardening starts immediately after mixing.
Practical hardness will be obtained within 60 minutes. The surface will be tacky within 5 minutes and nearly hardened after 15 minutes. It takes
12 hours for the surface to harden thoroughly 68 degrees F (20 degrees C)
-3. Sanding can be done after:
3 hours 68 degree F(20 degree C) - natural drying
30 minutes 140 degree (60 degree C) - baked
3. Primer Surfacer
NOTE: Use a dual-liquid type bumper primer surfacer (gray).
-
The primer surface is used to protect the PP resin surface and to fill cavities or flaws in the intermediate and top coats.
-
Mix 10 parts of primer surfacer and 1 part of hardener. Add the specific thinner (30-60%) to the mixture of the hardener and primer to attain
the proper viscosity for spraying.
4. Intermediate and Top Paint Coats (body color)
NOTE:
-
The paints are the dual liquid type based on the color chart.
-
Measure the pigment and hardener as described so they are in correct ratio.
-
Use the acrylic urethane paint prepared according to the mixing chart as the intermediate coat.
Mixing Ratio:
Mix 5 parts of body color pigment to 1 part of additive.
Mix 4 parts of the mixture of the pigment and additive with 1 part of the hardener.
NOTE:
-
Dilute the mixture with 40-50% of the specified thinner (Highart Thinner).
-
Be sure to mix the correct amount of the additive.
-
Use a spray gun to apply the paint. Do not use a brush.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening the paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection, and appropriate clothing when painting.
-
Paint is flammable. Store it in a safe place, and keep it away from sparks, flames, or cigarettes.
Drying time:
Natural 68 degrees F(20 degrees C)
Surface only 20 minutes
Almost hardened 4 hours
Throughly hardened 96 hours
NOTE: The HIGH ART MAT BLACK SURFACER is a dual liquid type. If mixed, it will harden in a matter of hours.
