Accord LX Coupe V6-3.0L (2001)
3.
Wash your hands thoroughly before applying the tape.
4.
Measure and cut off a 270 cm (106 inches) piece of tape.
5.
Peel oft about 5 cm (2 inches) of backing. Hold the tape at the very end of the exposed section.
6.
Start at the middle of either the right or left side of the moonroof opening and apply 2.5 cm (1 inch) of the tape at the top edge of the moonroof
opening. Do not apply the portion you touched with your finger or apply the tape above the edges of the opening.
NOTE:
Leave enough space to cut oft the section of tape that you touched with your finger.
7.
Remove the contaminated portion you touched with your finger.
8.
Hold the tape up to the roof opening, and peel the backing away from the tape as you move along the opening. Apply about 7.5 cm (3 inches) at a
time. Do not apply the tape above the edge of the opening.
9.
Carefully slide the thumb of your free hand along the tape, removing any air bubbles.
10.
Repeat steps 5 and 9 until you have applied the tape around the entire opening and until the ends of the tape butt together. Do not overlap the ends
of the tape. Cut off any excess tape.
11.
Open and close the moonroof several times to ensure that it operates smoothly.
NOTE:
Do not apply grease to the moonroof seal. The seal makes noise only when moved excessively. When the vehicle is driven, the glass does not
