Accord LX Coupe V6-3.0L (2001)
4. Insert the intake and exhaust valves in the head and measure the valve stem installed height (A).
5. If the valve stem installed height is over the service limit, replace the valve and recheck. If it is still over the service limit, replace the cylinder
head; the valve seat in the head is too deep.
Valves, Springs and Valve Seals Installation
Special Tools Required
^
Valve Spring Compressor Attachment 07757-PJ1010A or 07VAE-001010A
^
Commercially available Valve Spring Compressor KD383 with No.32 jaws, commercially available
^
Commercially available Valve Guide Seal Remover KD3372, commercially available
1. Coat the valve stems with engine oil. Install the valves in the valve guides.
2. Check that the valves move up and down smoothly.
3. Install the spring seats on the cylinder head.
4. Install the new valve seals (A) using the valve guide seal installer (B).
NOTE: Exhaust valve seals (c) have a black spring (D) and intake valve seals (E) have a white spring (F); they are not interchangeable.
