Accord LX Coupe V6-3.0L (2001)
9.
Remove the mounting screws from the OPDS unit and gently pull out the unit.
10.
Unplug the electrical connectors, then remove the unit.
11.
Install the new OPDS unit, then snap the new cover in place.
12.
Slip the seat-back cover over the OPDS unit.
13.
Accord models only: Check the attachment bosses for the clips:
^
If the seat-back has a pocket,and the attachment bosses are deformed or broken, or were damaged when you removed the seat-back panel, do
the repair procedure in S/B 02-010, Seat-Back Panel Is Loose or Detached, found under Body. Then go to step 14.
^
If the seat-back has no pocket, and the attachment bosses are deformed or broken, or were damaged when you removed the seat-back panel,
replace the seat-back. Then go to step 14.
^
If the attachment bosses are OK, go to step 14.
14.
Accord models only: Install the new clips in the seat-back panel. Turn the clips so the retaining tabs on the clips are horizontal. This ensures that
the clips fully set into the mounting holes in the seat.
