honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Timing Belt|Removal|Page 1406 > < Timing Belt|Specifications|Page 1403
Page 1
background image

Timing Belt: Service and Repair
Removal

NOTE:

^

Replace the timing belt and timing balancer belt at 105,000 miles (168,000 km) according to the maintenance schedule (normal conditions/severe
conditions).
If the vehicle regularly is driven in one or more of the following conditions, replace the timing belt and timing balance belt at 60,000 miles
100,000 km.

^

In very high temperatures (over 110°F, 43°C).

^

In very low temperatures (under -20°F, -29°C).

^

Turn the crankshaft pulley so the No. 1 piston is at Top Dead Center (TDC) before removing the belt.

^

Inspect the water pump. Refer to Cooling System.

^

The original radio has a coded theft protection circuit. Be sure to get the customer's code number before

-

disconnecting the battery.

-

removing the No. 39 (7.5 A) fuse from the underhood fuse/relay box.

-

removing the radio.

After service, reconnect power to the radio and turn it on.
When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio operation.

1. Disconnect the battery negative terminal first, then the positive terminal.
2. Remove the wheelwell splash shield.

3. Loosen the adjusting bolt and mounting nuts, then remove the Power Steering (P/S) pump belt.

Timing Belt|Removal|Page 1406 > < Timing Belt|Specifications|Page 1403