Accord LX Sedan L4-2156cc 2.2L SOHC MFI (1997)
Steering Gear: Service and Repair
Removal and Installation
Removal
TOOL REQUIRED
-
07MAC-SL00200 Ball Joint Remover, 28 mm
NOTE: Using solvent and a brush, wash any oil and dirt off the valve body unit and its lines, and the end if the gearbox. Blow dry with compressed air.
1. Drain the power steering fluid.
2. Raise the front of vehicle, and support it on safety stands in the proper locations.
3. Remove the front wheels.
4. Remove the driver's airbag assembly and steering wheel.
5. Remove the steering joint cover.
6. Remove the steering joint bolts, then disconnect the steering joint by moving the joint toward the column.
7. Remove the cotter pin from the tie-rod ball joint castle nut, and remove the nut.
