Accord LX Sedan L4-2156cc 2.2L SOHC MFI (1997)
31. Press the valve oil seal and roller bearing out of the valve housing using a hydraulic press and special tool shown below.
Assembly
NOTE:
-
Clean the disassembled parts with a solvent, and dry them with compressed air. Do not dip the rubber parts in a solvent.
-
Always replace the O-rings and rubber seals with new ones before assembly.
-
Apply recommended power steering fluid to the parts indicated in the assembly procedures.
-
Do not allow dust, dirt, or other foreign materials to enter the power steering system.
-
Use the appropriate special tools where necessary.
1. Apply vinyl tape to the stepped portion of the pinion shaft, and coat the surface of the vinyl tape with the power steering fluid.
2. Install the backup ring with its tapered side as shown above.
3. Coat the inside surface of the new valve oil seal with power steering fluid.
4. Slide the valve oil seal over the pinion shaft, being careful not to damage the sealing lip.
CAUTION: Install the valve oil seal with its grooved side facing opposite the bearing.
