Accord LX Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-1326003.png)
5.
Remove the PCV valve from the PCV hose. Remove the PCV hose from the intake manifold. Save one of the hose clamps for reassembly, and
discard the PCV hose.
6.
Use an 8-mm drill bit and carburetor cleaner to clean the EGR port in the manifold. Turn the drill bit only by hand. Do not use a power drill. After
you clean the EGR port, use carburetor cleaner to thoroughly clean the inside of the manifold.
7.
Check the EGR port in the front injector base on the engine for blockage. If you see any blockage, clean the EGR port.
8.
Install the intake manifold cover brackets you saved in step 4 on the new intake manifold chamber.
9.
Connect the new PCV hose to the PCV port on the bottom of the manifold chamber. Secure it with the new 12 mm hose clamp. Position the hose
clamp with its tangs facing towards the manifold chamber.
10.
Install the manifold chamber onto the manifold with the gaskets, brace, and mounting hardware you saved in step 4. Torque the bolts and nuts to
12 Nm (8.7 lb-ft).
11.
Connect the new PCV hose to the PCV valve with the hose clamp you saved in step 5.
12.
Install the PCV cap onto the old PCV port on the manifold. Secure it with the new 15.5 mm diameter hose clamp.
