Accord LX Sedan L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-2029017.png)
To keep debris out of the ignition switch, do not clean it with compressed air.
21.
Attach the slide hammer to a new lever pin, then insert the lever into the ignition switch body, and seat the pin with the slide hammer.
22.
Use vernier calipers to measure the installed height of the lever pin. The height should be close to the measurement you made in step 5 of the
inspection procedure. If the height is more than 5.3 mm, the pin is not seated. If needed, reattach the slide hammer, then seat the pin.
NOTE:
It's normal for the interlock lever to be loose, even when the pin is fully seated.
