Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
10. Install the plastic cover and bracket.
NOTE
^
Apply adhesive along the edge where necessary to maintain a continuous seal and prevent water leaks.
^
Do not plug the elongated hole.
11. Install the door panel.
NOTE:
^
Make sure the door harness is not pinched.
^
If necessary, replace any damaged clips.
^
Make sure the connectors are connected properly.
12. Install the armrest pocket and inner handle.
NOTE: Make sure the connector is connected properly.
13. Install the inner trim cover.
14. If applicable, install the regulator handle.
NOTE: Raise the glass fully
1. Remove:
^
Inner trim cover.
^
Door panel.
^
Plastic cover.
