Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
13.
Remove the oil pump housing bolt to the left and below the front balancer shaft.
14.
Install the oil seal retainer from the kit on the pump housing with the bolt you just removed. Torque the bolt to 12 Nm (8.7 lb-ft).
15.
Reinstall the lower cover bolts, making sure the rubber seal seats properly in the cover. Torque the bolts to 12 Nm (8.7 lb-ft).
16.
Reinstall the crankshaft pulley. Use the special tools and a torque wrench to torque the pulley bolt to 245 Nm (181 lb-ft). Make sure you use a
torque wrench; do not use an impact wrench.
17.
Reinstall the splash shield mounting bolts. Torque the bolts to 12 Nm (8.7 lb-ft).
18.
Reinstall the left front wheel. Torque the wheel nuts to 108 Nm (80 lb-ft).
19.
Reinstall the dipstick tube with the new O-ring from the kit. Torque the bolt to 12 Nm (8.7 lb-ft). Reinstall the dipstick.
20.
DOHC Prelude only: Reinstall the power steering reservoir and the power steering pump.
21.
Reinstall the alternator belt and the power steering pump belt.
22.
Tighten the adjusting bolts for the alternator and the power steering pump 20 turns, then torque the mounting hardware as specified in the
appropriate service manual. Use belt tension gauge T/N 07JGG-001010A or TGG-001000A to check for proper belt tension.
