Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Horn Switch: Testing and Inspection
Switch Test
CAUTION:
^ All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness, disconnect the airbag
connectors.
^ Whenever the ignition switch ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags could
accidentally deploy and cause damage or injuries.
^ For additional precautions, refer to Air Bags and Seat Belts.
NOTE: The original radio has a coded theft protection circuit. Be sure to get the customer's code number before
-
disconnecting the battery.
-
removing the No. 39 (7.5 A) fuse from the under hood fuse/relay box.
-
removing the radio.
After service, reconnect power to the radio and turn it on. When the word "CODE" is displayed, enter the customer's 5-digit code to restore radio
operation.
1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
2. Disconnect the airbag connectors.
Driver's Side:
^ Remove the access panel from the steering wheel, then disconnect the 2-P connector between the driver's airbag and cable reel.
Front Passenger's Side:
^ Remove the glove box.
^ Disconnect the 2-P connector between the front passenger's airbag and SRS main harness.
3. Remove the dashboard lower cover and knee bolster.
Switch Test
4. Disconnect the 20-P connector between the combination switch harness and main wire harness.
