Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Airbag Assembly Replacement
Remove the two Torx bolts using a Torx T30 bit, then remove the driver's airbag assembly.
CAUTION: Be sure to install the SRS Wiring so that it is not pinched or interfering with other parts.
5. Install the new airbags:
Airbag Assembly Replacement
Place the driver's airbag assembly into the steering wheel, and secure it with new Torx bolts.
6. Reconnect the airbag connectors.
Airbag Assembly Replacement
Connect the driver's airbag 2P connector to the cable reel 2P connector, then install the access panel on the steering wheel.
7. Connect the battery positive cable, then connect the negative cable.
8. After installing the airbag assembly, confirm proper system operation:
-
Turn the ignition switch ON (II): the SRS indicator light should come on for about six seconds and then go off.
-
Make sure both horn buttons work.
-
Take a test drive, and make sure the cruise control switches work.
9. Enter the code number to restore radio operation.
