Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Clockspring Assembly / Spiral Cable: Service and Repair
Installation
1. Before installing the steering wheel, the front wheels should be aligned straight ahead.
2. Disconnect the battery negative cable, and wait at least three minutes.
3. Set the cancel sleeve (A) so that the projections (B) are aligned vertically.
4. Carefully install the cable reel (A) on the steering column shaft. Then connect the 4P connector (B) to the cable reel, and connect the 2P connector
(C) to the SRS main harness 2P connector (D).
5. Install the steering column covers.
6. If necessary, center the cable reel. (New replacement cable reels come centered.) Do this by first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (approximately two and a half turns) until the arrow mark on the cable reel label points straight up.
