Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Set/Resume Switch Test/Replacement
5. Check for continuity between the terminals of the 20-P connector in each switch position according to the table.
^ If there is continuity, and it matches the table, the switch is OK.
^ If there is no continuity in one or both positions, go to step 6.
6. Remove the steering column covers.
7. Disconnect the combination switch harness 4-P connector from the cable reel.
Set/Resume Switch Test/Replacement
8. Check for continuity between the terminals as shown:
^ If there is no continuity, replace the combination switch harness.
^ If there is continuity, go to step 9.
Set/Resume Switch Test/Replacement
9. Carefully remove the set/resume switch cover by prying between the cover and the switch in the sequence shown.
