Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Dimmer Switch: Testing and Inspection
Dash Light Controller Input Test
Controller Input Test
NOTE: The control unit is built into the dash lights brightness controller.
1. Carefully pry the controller out of the dashboard, then disconnect the 3-P connector from the controller.
2. Inspect the connector and socket terminals to be sure they are all making good contact.
^ If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
^ If the terminals look OK, make the following input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the controller must be faulty; replace it.
