Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Wiper Switch: Testing and Inspection
Wiper/Washer Switch Test
Windshield Wiper/Washer Switch
1. Remove the dashboard lower cover and knee bolster.
2. Disconnect the 7-P and 20-P connectors from the main wire harness.
3. Inspect the connector terminals to be sure they are all making good contact.
^ If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
^ If the terminals look OK, check for continuity between them in each switch position according to the table.
-
If there is no continuity between any of them, check for continuity in the switch harness.
-
If there is continuity in the switch harness, replace the wiper/washer switch.
-
If there is no continuity in the switch harness, replace it.
