Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Wheels: Service and Repair
WHEEL RUNOUT
NOTE: These dimensions ONLY apply to factory equipment.
1. Raise the vehicle off the ground, and support it with safety stands in the proper locations.
2. Check for bent or deformed wheels.
3. Attach the dial gauge as shown.
4. Measure the wheel runout by turning the wheel.
Front and Rear Wheel Axial Runout:
Standard:
Steel Wheel: 0 - 1.0 mm (0 - 0.04 inch)
Aluminum Wheel: 0 - 0.7 mm (0 - 0.03 inch)
Service Limit: 2.0 mm (0.08 inch)
Front and Rear Wheel Radial Runout:
Standard:
Steel Wheel: 0 - 1.0 mm (0 - 0.04 inch)
Aluminum Wheel: 0 - 0.7 mm (0 - 0.03 inch)
Service Limit: 1.5 mm (0.06 inch)
5. If the wheel runout is more than the service limit, replace the wheel.