Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Carrier Bearings: Service and Repair
NOTE: Check the bearings for wear and rough rotation. If the bearings are OK, removal is not necessary.
BEARING REPLACEMENT
1. Remove the tapered roller bearings using a bearing puller.
2. Install the new tapered roller bearings, using the special tool and a press as shown.
NOTE:
-
Press the bearings on until they bottom.
-
Use the large end of the special tool for torque converter housing side bearing.
-
Use the small end of the special tool for transmission housing side bearing.
NOTE:
-
The bearing and outer race should be replaced as a set.
-
Inspect and adjust the bearing preload whenever a bearing is replaced.
-
Drive in the bearings securely so that there is no clearance between the bearings and differential carrier.
BEARING OUTER RACE REPLACEMENT
TOOL REQUIRED
-
07749-0010000 Driver
-
07HAD-SF10100 Driver Attachment