Accord SE Coupe L4-2156cc 2.2L SOHC MFI (1997)
Carrier Bearings: Service and Repair
TOOL REQUIRED
-
07746-0030100 Driver, 40 mm I.D.
TAPERED ROLLER BEARING REPLACEMENT
NOTE:
-
The tapered roller bearing and bearing outer race should be replaced as a set.
-
Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
-
Check the tapered roller bearings for wear and rough rotation. If the tapered roller bearings are OK, removal is not necessary.
1. Remove the tapered roller bearings using a bearing puller and a bearing separator as shown.
2. Install new tapered roller bearings using the special tool as shown.
NOTE: Drive the tapered roller bearings on until they bottom against the differential carrier.
BEARING OUTER RACE REPLACEMENT
NOTE:
-
The bearing outer race and tapered roller bearing should be replaced as a set.
-
Inspect and adjust the tapered roller bearing preload whenever the tapered roller bearing is replaced.
1. Remove the oil seals from the transmission housing and clutch housing.
