Accord Sedan L4-2.2L SOHC (16 Valve) (1996)
1. Using the special tool, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess
grease off the crankshaft, and check that the oil seal lip is not distorted.
2. Using the special tool, drive in the front balancer shaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any
excess grease off the balancer shaft, and check that the oil seal lip is not distorted.
3. Using the special tool, drive the crankshaft oil seal into the right side cover to the point where the clearance between the bottom of the crankshaft
oil seal and right side cover is 0.5 - 0.8 mm (0.02 - 0.03 in)
NOTE: Align the hole in the driver attachment with the pin on the crankshaft.