Accord Sedan L4-2.2L SOHC (16 Valve) (1996)
/Page-6001.png)
Power Door Lock Control Module: Testing and Inspection
Without Keyless Entry
Control Unit Input Test (Without Keyless Entry)
1. Remove the driver's door panel (see section 20).
2. Disconnect the 14-P connector from the control unit.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
^
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
^
If the terminals look OK, make the following input tests at the connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the control unit must be faulty; replace it.
