Accord Sedan L4-2.2L SOHC (16 Valve) (1996)
Countershaft: Testing and Inspection
Inspection
1. Inspect the gear surface and bearing surface for wear and damage, then measure the countershaft at points A, B, and C.
-
If any part of the countershaft is less than the service limit, replace it with a new one.
2. Inspect for runout.
Standard: 0.02 mm (0.D008 in) max.
Service Limit: 0.05 mm (0.002 in)
NOTE:
-
Support the countershaft at both ends as shown
-
If the runout exceeds the service limit, replace the countershaft with a new one.