Accord Sedan V6-2.7L SOHC (24 Valve) (1996)
/Page-1709002.png)
5. Disconnect the connector from the A/C thermostat.
Remove the four self-tapping screws, two mounting nuts and the mounting bolt.
Disconnect the drain hose, then remove the evaporator.
6. Install in the reverse order of removal. Make note of the following items.
-
If you're installing a new evaporator, add refrigerant oil (Sanden SP-10, Part No. 38899-P13-A01).
-
Replace the 0-rings with new ones at each fitting, and apply a thin coat refrigerant oil (Sanden SP-10, Part No. 38899-P13-A01) before
installing them.
NOTE: Be sure to use the right 0-rings for HFC 134a (R-134a) to avoid leakage.
-
Apply sealant to the grommets.
-
Make sure that there is no air leakage.
-
Charge the system, and test its performance.
