Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
ABS Pump Motor: Service and Repair
WARNING: The modulator unit contains high-pressure brake fluid Be sure to bleed the high-pressure fluid from the modulator unit before
removing the pump motor.
-
Bleed the high-pressure brake fluid from the modulator unit.
-
Remove the modulator unit from the vehicle.
-
Remove the 8 mm flange bolts from the modulator unit, and remove the pump motor.
-
Install the pump motor in the reverse order of removal.
Specs:
Flange Bolt 15 Nm (11 lb.ft.)
NOTE:
-
After installing the modulator unit, add fresh brake fluid until the reservoir is refilled to the specified level, and bleed air from the system.
-
Turn the ignition switch ON (II), and check for the ABS indicator light operation.