Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
16. Use the ball joint remover, 32mm, as shown to separate the lower ball joint and lower arm.
NOTE:If necessary, apply penetrating type lubricant to loosen the ball joint.
17. Remove the knuckle protector.
18. Remove the cotter pin from the upper ball joint castle nut, and remove the nut.
19. Install a 10mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
20. Use the ball joint remover as shown to separate the upper ball joint and knuckle.
NOTE:If necessary, apply penetrating type lubricant to loosen the ball joint.