Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
Proper Angle
2. Before installing the modulator unit on the vehicle, be sure to bleed the air from the suction port in the modulator unit by leaning the modulator
unit to one side slowly (about 45 degrees) as shown.
Brake Line Placement
3. Install the modulator unit in the reverse order of removal.
NOTE: Check the letters stamped on the modulator body, and connect the brake lines properly. Tighten the flare nuts.
Specs:
Flare nuts 19 Nm (14 lb.ft.)
4. Start the engine and let it idle for a minute.
Check that:
-
ABS indicator light is off.
-
Brake fluid is not leaking from the brake line joints.
5. Stop the engine.