Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
Front Steering Knuckle: Service Precautions
CAUTION:
-
The vehicle should be on the ground before any bolts or nuts connected to rubber mounts or bushings are tightened.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the pin hole. Do not align the nut by
loosening.
-
Replace the self-locking nuts after removal.
NOTE:
-
Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage the aluminum wheels.
-
On the aluminum wheels, remove the center cap from the inside of the wheel after removing the wheel.
-
Before installing the brake disc, clean the mating surfaces of the front hub and brake disc.
-
Before installing the wheel, clean the mating surfaces of the brake disc and wheel.
-
Wipe off the grease before tightening the nut at the ball joint.