Accord Wagon EX L4-2156cc 2.2L SOHC (VTEC) MFI (1997)
_mfi/Page-1588004.png)
1. Wrap the splines with vinyl tape to prevent damage to the boots and dynamic damper.
2. Install the outboard boot, dynamic damper and inboard boot to the driveshaft, then remove the vinyl tape.
CAUTION: Take care not to damage the boots and dynamic damper.
3. Install the stop ring into the driveshaft groove.
NOTE: Always rotate the stop ring in its groove to be sure it is fully seated.
4. Install the spider on the driveshaft by aligning the marks on the spider and end of the driveshaft.
5. Fit the circlip into the driveshaft groove.
NOTE: Always rotate the circlip in its groove to be sure it is fully seated.
6. Pack the outboard joint with the joint grease included in the new driveshaft set. Grease quantity: 130 - 140 g (4.6 - 4.9 oz)
