Civic L4-1.3L Hybrid (2008)
3. Attach the driveshaft on the drive motor assembly to the mounting yoke, making sure the center line of the driveshaft is level with the spindle nut on
the wheel hub.
4. Set the lower toggle switch on the drive motor assembly to FWD (counterclockwise rotation) or REV (clockwise rotation).
Setting Up and Adjusting the Brake Lathe
Use Kwik-Way cutting bits, P/N KWY-109109223, and the holding screws that come with them. These bits are stamped KW and are available through
the Honda Tool and Equipment Program (see ORDERING INFORMATION).
Before you use the brake lathe, inspect the tips of the cutting bits with a magnifying glass to make sure the tips are not worn out. Each bit has three tips.
If a tip is worn, rotate the bit, and use a new tip. A worn tip produces a poor finish and may cause chattering.
