Civic L4-1.3L Hybrid (2008)
7. Repeat the procedure for each brake circuit until no air bubbles are in the fluid.
8. Refill the master cylinder reservoir tank to the middle of the tank line.
9. Inspect the brake fluid level.
10. Turn the ignition switch to ON (II), and check for the AHB indicator or brake system indicator to come on in the gauge control module (tach).
^
If the indicator(s) come on and stay on, turn the ignition switch to LOCK (0), and do the servo unit and power unit bleeding procedure.
^
If the indicators come on and then go off, the system is OK.
Bleeding - Servo Unit and Power Unit
1. Remove the air cleaner.
2. Do the normal brake system bleeding (except the servo unit and power unit).
3. Remove the IMA system power cable clamp (A).
4. Disconnect the auxiliary electric water pump connector (A).
