Civic L4-1.3L Hybrid (2008)
Crankshaft Main Bearing Seal: Service and Repair
Transmission End Crankshaft Oil Seal Installation - In Car
Special Tools Required
^
Driver 07749-0010000
^
Oil seal driver attachment 07ZAD-PNA0100
1. Remove the IMA motor housing.
2. Remove the transmission end crankshaft oil seal.
3. Clean and dry the crankshaft oil seal housing.
4. Apply a light coat of multipurpose grease to the crankshaft and to the lip of the seal.
5. Using the special tools, drive in the crankshaft oil seal until the driver attachment bottoms against the engine block end cover. Align the hole in the
driver attachment with the pin on the crankshaft.
6. Measure the distance between the crankshaft (A) and the oil seal (B).
7. Clean any excess grease off the crankshaft, and check that the oil seal lip is not distorted.
8. Install the IMA motor housing.
