Civic L4-1.3L Hybrid (2008)
Drive Motor Power Cable: Service and Repair
Motor Power Cable Removal/Installation
NOTE: Put on gloves to protect your hands from electrical shock.
IMA components are located in this area. The IMA is a high-voltage system. You must be familiar with the IMA system before working on or around it.
Make sure you have read the IMA service precautions before doing repairs or service.
1. Make sure you have the anti-theft code for the audio unit or the navigation system (if equipped), then write down the audio presets.
2. Make sure the ignition switch OFF.
3. Disconnect the negative cable from the 12 V battery.
4. Remove the IPU lid.
5. Disconnect the A/C compressor power cable connector (A) from the A/C compressor driver, then wrap the cable end with insulating tape.
6. Remove the wires (A) from the DC-DC converter.
7. Lift the IPU wire harness (A).
8. Remove the PCU cover (A).
