Civic L4-1.3L Hybrid (2008)
8. Inspect the quality of the wire crimp. If it has any of the shown NO GOOD crimps, cut it off and start over.
9. Insert the terminal into the connector. Make sure the wire seals are pushed all the way into the connector. Lightly pull on the wires to make sure
the terminal is locked into place.
10. Close or insert the secondary terminal lock, if applicable, and reconnect the connector.
How to Install Pigtail Terminals
HOW TO INSTALL PIGTAIL TERMINALS
Pigtail terminals (short pieces of wire with a factory crimped terminal) are used when the wire is too short or when access to the connector is too
restricted to make a terminal repair.
NOTE: To replace just a connector terminal, go to How to Replace Connector Terminals.
IMPORTANT SAFETY INFORMATION:
On some models, the SRS wires are in a separate harness. If the SRS harness is damaged, replace the harness; do not repair it. On other
models, wire harnesses include yellow SRS wires. If any SRS wire is damaged, replace the entire harness; do not repair it.
1. Remove the damaged or faulty terminal from the connector. Use the proper removal tool from Pin Tool Set.
