honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Malfunction Indicator Lamp - Hybrid Drive|Testing and Inspection|Page 1525 > < Malfunction Indicator Lamp - Hybrid Drive|Testing and Inspection
Page 2
background image

Is there 12 V battery voltage?

YES - Go to step 13.

NO -
-

Repair open or short in the wire between the No. 10 METER (7.5 A) fuse in the under-dash fuse/relay box and the BCM module (A29).

-

Replace the No. 10 METER (7.5 A) fuse.

13. Turn the ignition switch OFF.
14. Reconnect BCM module connector A (40P).
15. Turn the ignition switch ON (II).
16. Measure voltage between body ground and BCM module connector terminals A2 and A3.

Is there 72 V battery voltage?

YES - Go to step 17.

NO - Go to step 20.

17. Turn the ignition switch OFF.
18. Disconnect BCM module connector A (40P).
19. Check for continuity between body ground and BCM module connector terminals A8*, A9, A22*, and A23 individually.

Is there continuity?

YES - Update the BCM module if it does not have the latest software, or substitute a known-good BCM module, then recheck. If the
symptom/indication goes away with a known-good BCM module, replace the original BCM module

Malfunction Indicator Lamp - Hybrid Drive|Testing and Inspection|Page 1525 > < Malfunction Indicator Lamp - Hybrid Drive|Testing and Inspection