Civic L4-1.3L Hybrid (2008)
-
Door-open and trunk-open indicators
-
Horns (security and panic)
-
Chimes (key-in, seat belt, lights-on, and parking brake)
-
Power window
-
Wiper/washer
-
Security
-
Keyless entry
-
Power door locks
-
Climate control
-
Key interlock
-
Dash light brightness
Is the symptom related to the B-CAN system?
YES - Go to step 2.
NO - Go to the system troubleshooting for the system with the symptom.
2. Connect the HDS to the data link connector (A), then turn the ignition switch to ON (II).
3. From the BODY ELECTRICAL menu, select UNIT INFORMATION, and then select CONNECTED UNIT listed to see if the following control
units are communicating with the HDS.
-
MICU
-
Gauge control module
-
Climate control unit
-
Immobilizer-keyless control unit
NOTE:
-
If a unit is communicating with the HDS, DETECT will be displayed.
-
If a unit is not communicating or the vehicle is not equipped, "Not Available" will be displayed.
Are all control units communicating with the HDS?
YES - Go to step 4.
NO - If any of the control units are not communicating, go to B-CAN System Diagnosis Test Mode B. If all units are not communicating or only
the MICU is communicating, go to DTC B1000 troubleshooting. See: Testing and Inspection/Diagnostic Trouble Code Tests and Associated
Procedures/B Code Charts/B1000
4. Select the system that has the problem from the BODY ELECTRICAL menu, then select DTCs.
Are any DTCs indicated?
YES - Go to step 5.
NO - If the problem is related to one of the following items, go to B-CAN System Diagnosis Test Mode C if the system does not stop or turn off.
Go to test mode D if the system does not run or turn on.
-
Exterior lights
-
Turn signals
-
Entry light control
-
Interior lights
