Civic L4-1.3L Hybrid (2008)
NOTE:
Three DTCs may be stored after the software is installed. These DTCs can be erased only after all updates (PGM-FI, A/T (CVT), and IMA
battery) are completed. For more information on the three DTCs, refer to Service Bulletin 09-026, 2006-09 Civic Hybrid, 2010 Insight New
DTCs U0301, U0302, and U0312.
2. Do the CKP pattern learn procedure with the HDS:
^
In the ADJUSTMENT MENU of the HDS, select CRANK PATTERN.
^
Select CRANK PATTERN LEARNING, and follow the screen prompts.
3. Do the idle learn procedure:
^
Make sure all electrical accessories (A/C, radio, lights, etc.) are off.
^
Start the engine, and let it run until it reaches normal operating temperature (the cooling fans have cycled twice).
^
Let the engine idle for 10 minutes.
4. If you updated the CVT software, select START CLUTCH FEEDBACK LEARN in the HDS, and follow the screen prompts to calibrate the start
clutch pressure control.
5. If needed, use the HDS to clear all DTCs from all systems.
6. Center-punch a completion mark below the fifth character of the engine compartment VIN:
^
Slide open the FRAME NUMBER door on the center cowl cover.
^
Use a long punch to reach the VIN.
Disclaimer
