Civic L4-1.3L Hybrid (2008)
Impact Sensor: Service and Repair
Side Impact Sensor (Second) Replacement
Side Impact Sensor (Second) Replacement
Removal
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the appropriate side curtain airbag 2P connector.
3. Remove the rear seat and seat side bolster.
4. Disconnect the floor wire harness 2P connector from the side impact sensor (second).
5. Remove the TORX bolt (A) using a TORX T30 bit, then remove the side impact sensor (second) (B).
Installation
1. Install the side impact sensor (second) with a new TORX bolt (A), then connect floor wire harness 2P connector (6) to the side impact sensor
(second).
2. Reconnect the negative cable to the battery.
3. After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should
come on for about 6 seconds and then go off.
4. Reinstall all removed parts.
