Civic L4-1.3L Hybrid (2008)
4. Using the pin driver to position the spring washers, torque the TORX nuts is the sequence shown in two or more steps.
5. Check whether there is a gap of 4 mm or more at each of the four locations.
6. Reassemble the front passenger's seat cushion cover/pad.
7. Reinstall the front passenger's seat.
8. Reconnect the negative cable to the battery.
9. Calibrate the ODS unit.
10. After installing the front passenger's weight sensors, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator
should come on for about 6 seconds and then go off.