Civic L4-1.3L Hybrid (2008)
17.
Turn the ignition switch to ON (II).
18.
After turning the ignition switch to ON (II), the SRS indicator comes on for 6 seconds and then goes off. Within 4 seconds after the indicator goes
off, disconnect the SCS service connector from the MES connector.
19.
Within 4 seconds after the SRS indicator comes on again, reconnect the SCS service connector to the MES connector.
20.
Within 4 seconds after the SRS indicator goes off, disconnect the SCS service connector from the MES connector. The SRS indicator blinks twice
to indicate the SRS unit memory has been cleared.
21.
Turn the ignition switch to LOCK (0), and wait for 10 seconds.
22.
Turn the ignition switch to ON (0). The SRS indicator should come on for 6 seconds and then go off. If the indicator stays on, repeat steps 14 thru
22. If after doing those steps the indicator continues to stay on, read and troubleshoot the SRS DTCs or refer to symptom troubleshooting.
23.
Use the HDS to remove the short on the SCS line.
ODS UNIT CALIBRATION WITH MANUAL MODE
NOTE:
Always calibrate the ODS unit after replacing any of the front passenger's seat components (except the ODS unit or the seat weight sensors), after a
vehicle collision, or after replacing the SRS unit.
1.
Make sure there are no SRS DTCs.
2.
Adjust the front passengers seat to its most rearward position, and adjust the seat-back to the forward-most position. Make sure to remove items
that are on, under, or near the seat.
3.
Turn the ignition switch to LOCK (0).
4.
If not already connected, connect the HDS to the DLC, then turn on the HDS (but do not turn the ignition switch to ON (II).
5.
Select the Diagnostic System icon to run the HDS.
6.
Select the SCS icon.
7.
On the next screen, select YES to short the SCS line. After the line is shorted, the odometer display flashes no.
8.
Buckle the driver's seat belt.
9.
Turn the ignition switch to ON (II).
10.
After turning the ignition switch to ON (II), the SRS indicator comes on for 6 seconds and then goes off. Within 4 seconds after the indicator goes
off, unbuckle the driver's seat belt.
11.
Within 4 seconds after the SRS indicator comes on again, buckle the driver's seat belt.
12.
Within 4 seconds after the SRS indicator goes off, unbuckle the driver's seat belt.
13.
Watch the SRS indicator:
^
If the SRS indicator blinks twice and then goes off, the ODS unit is calibrated. Turn the ignition switch to LOCK (0), then go to FRONT
PASSENGER'S SEAT WEIGHT SENSOR OUTPUT CHECK AFTER A VEHICLE COLLISION WITH MANUAL MODE.
^
If the SRS indicator blinks twice and then stays on, the ODS unit is calibrated, but there are SRS DTCs that need to be cleared. Go to step 14.
^
If the SRS indicator stays on (does not blink), the ODS unit is not calibrated. Repeat steps 8 thru 13. If after three attempts the ODS unit does
not calibrate, refer to symptom troubleshooting in the service manual.
14.
Turn the ignition switch to LOCK (0).
15.
Disconnect the HDS.
