Civic L4-1.3L Hybrid (2008)
16.
Connect the SCS service connector to the 2P memory erase signal (MES) connector. Do not use a jumper wire.
17.
Turn the ignition switch to ON (II).
18.
After turning the ignition switch to ON (II), the SRS indicator comes on for 6 seconds and then goes off. Within 4 seconds after the indicator goes
off, disconnect the SCS service connector from the MES connector.
19.
Within 4 seconds after the SRS indicator comes on again, reconnect the SCS service connector to the MES connector.
20.
Within 4 seconds after the SRS indicator goes off, disconnect the SCS service connector from the MES connector. The SRS indicator blinks twice
to indicate the SRS unit memory has been cleared.
21.
Turn the ignition switch to LOCK (0), and wait for 10 seconds.
22.
Turn the ignition switch to ON (I I). The SRS indicator should come on for 6 seconds and then go off. If the indicator stays on, repeat steps 14 thru
22. If after doing those steps the indicator continues to stay on, read and troubleshoot the SRS DTCs or refer to symptom troubleshooting.
23.
Use the HDS to remove the short on the SCS line.
FRONT PASSENGER'S SEAT WEIGHT SENSOR
OUTPUT CHECK AFTER A VEHICLE COLLISION
WITH MANUAL MODE
NOTE:
^
Always check the front passenger's seat weight sensor output after replacing any of the front passenger's seat components, except the ODS unit,
and after a vehicle collision.
^
Make sure the SCS line is not shorted by the HDS.
1.
Adjust the front passenger's seat to its most rearward position, and adjust the seat-back to a normal upright position. Make sure to remove items
that are on, under, or near the seat.
2.
Turn the ignition switch to ON (II), and wait for the passenger airbag OFF indicator to go off.
3.
Apply the specified weight to the front passenger's seat:
^
4-door: 58 pounds. (A case of Honda coolant is 58 pounds.)
^
2-door: 64 pounds. (A case of Honda coolant and a 1 gallon jug of VTM-4 fluid is 64 pounds.)
4.
For 2-door models: Firmly tap on the headrest twice to release any stiction that may be present in the seat weight sensors.
5.
Watch the passenger airbag OFF indicator. The indicator should come on and stay on. If the indicator does not come on, check for SRS DTCs and
troubleshoot them.
6.
Add another 15-20 pounds of weight to the front passenger's seat.
7.
For 2-door models: Firmly tap on the headrest twice.
8.
Watch the passenger airbag OFF indicator. The indicator should go off.
^
If the indicator goes off, the front passenger's weight sensors are OK.
^
If the indicator does not go off, check for SRS DTCs and troubleshoot them, then repeat steps 1 thru 8.
