Civic L4-1.3L Hybrid (2008)
^
Turn off the TPMS sensor tool by pressing and holding the small button as shown until the green light in the button turns off. The tool will also turn
off after 5 minutes of inactivity.
NOTE:
Offset your finger, or use just your nail to push the buttons, so you can see the light in the buttons.
AC Adapters for the TPMS Sensor Tool
Two AC adapters are included in the TPMS sensor tool kit. The 900 AC adapter is for the battery charger. Use the straight AC adapter to power the
TPMS sensor tool when charged batteries are not available.
NOTE:
^
The AC adapter does not charge the batteries in the TPMS sensor tool.
^
Remove the batteries from the TPMS sensor tool when using the AC adapter.
Using the Battery Charger
There are two ways to charge the batteries. The method to use depends on the batteries' state of charge. For brand new or fully discharged batteries:
1.
Connect the AC adapter to the charger (make sure you use the AC adapter with the 90° bend).
2.
Insert the batteries into the charger. Make sure you note the polarity (direction) of the batteries.
3.
Plug the charger into a power outlet. The LEDs turn red, and quick charging begins.
NOTE:
^
If the LEDs do not come on, check that the batteries are properly installed. If the LEDs still do not come on, replace the batteries.
^
If you press the red button while the batteries are charging, the battery discharge mode begins. Press the red button again within 30
seconds, and the charger switches back to its quick charge mode.
^
When the LEDs turn green, the batteries are charged, and the battery charger automatically switches to trickle charge mode.
^
Remove the batteries from the charger when it is not plugged in.
For charging batteries when you don't know the state of charge:
1.
Connect the AC adapter to the charger (make sure you use the AC adapter with the 90° bend).
2.
Insert the batteries into the charger. Make sure you note the polarity (direction) of the batteries.
3.
Plug the charger into a power outlet.
4.
Press the red button once to start the discharge mode. The LEDs blink red.
NOTE:
^
If the LEDs do not come on, check that the batteries are properly installed. If the LEDs still do not come on, replace the batteries.
^
If you press the red button a second time within 30 seconds, the battery quick charge mode begins.
^
Once the batteries are discharged, the LEDs turn solid red and the battery quick charge mode begins.
