Civic L4-1.3L Hybrid (2008)
7. Remove and replace the valve stem grommet (A) from the tire pressure sensor (B).
NOTE:
^
The valve stem grommet might stay in the wheel; make sure you remove it.
^
Always use a new valve stem grommet whenever the tire pressure sensor has been removed from the wheel. When only removing a tire from
the wheel, or when replacing the tire.
Installation
NOTE: Use only wheels that have a "TPMS" stamp (A) on them.
1. Before installing the tire pressure sensor, clean the mating surfaces on the sensor and the wheel.
2. Install the tire pressure sensor (A) and the washer (B) to the wheel (C), and tighten the valve stem nut (D) finger tight. Make sure the pressure
sensor is resting on the wheel.
NOTE: Install the tire pressure sensor so that the sensor housing surface (E) should not exceed the protrusion (F) of the wheel to prevent the
sensor housing caught in the bead of the tire when assembling the tire. Do not twist the sensor to adjust its position with the wheel, as this will
