Civic L4-1.3L Hybrid (2008)
Steering Wheel: Service and Repair
Steering Wheel Installation
Steering Wheel Installation
1. Before installing the steering wheel, make sure the front wheels are pointing straight ahead, then center the cable reel (A). Do this by first rotating
the cable reel clockwise until it stops. Then rotate it counterclockwise about three full turns. The arrow mark (B) on the cable reel label point
should point straight up.
2. Position the two tabs (A) of the turn signal canceling sleeve (B) as shown. Install the steering wheel on to the steering column shaft, making sure
the steering wheel hub (C) engages the pins (D) of the cable reel and the tabs of the turn signal canceling sleeve. Do not tap on the steering wheel
or steering column shaft when installing the steering wheel.
3. Install the steering wheel bolt (A), and tighten it to the specified torque. Connect the cable reel subharness connector (B). Make sure the wire
harness is routed and fastened properly.
4. Install the driver's airbag, and confirm that the system operating properly.
5. Reconnect the negative cable to the battery, and do these tasks:
