Civic L4-1.3L Hybrid (2008)
NOTE: Refer to the Exploded View, as needed, during this procedure.
1. Clean the disassembled parts with solvent, and dry them with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Press the intermediate shaft bearing (A) into the bearing support (B) using the 52 x 55 mm attachment (C), the driver (D) and a press.
3. Install the internal snap ring into the groove of the bearing support.
4. Press the intermediate shaft (A) into the new shaft bearing (B) using the 35 mm I.D. attachment (C) and a press.
5. Install the external snap ring (A) into the groove of the intermediate shaft (B).
