Civic L4-1.3L Hybrid (2008)
11. Remove the bolts (C), and loosen the bolt (D), then remove the regulator through the hole in the door.
12. Grease all the sliding surfaces of the regulator (A) where shown.
13. Install the glass and regulator in the reverse order of removal, and note these items:
-
Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks.
