Civic L4-1.8L (2006)
9. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
When installing, tie a string to the top end of the new drain tube and pull it up into the roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
10. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
4-door
1. Remove these items:
-
Headliner
-
Moonroof glass
2. Put on gloves to protect your hands. Disconnect the motor connector (A).
3. Disconnect the drain tubes (A).
4. Remove the interior harness (B) by detaching the harness clips (C).
